| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
clk: mediatek: Fix memory leaks on probe
Handle the error branches to free memory where required.
Addresses-Coverity-ID: 1491825 ("Resource leak") |
| In the Linux kernel, the following vulnerability has been resolved:
ceph: fix memory leak in ceph_readdir when note_last_dentry returns error
Reset the last_readdir at the same time, and add a comment explaining
why we don't free last_readdir when dir_emit returns false. |
| In the Linux kernel, the following vulnerability has been resolved:
net: airoha: Fix memory leak in airoha_qdma_rx_process()
If an error occurs on the subsequents buffers belonging to the
non-linear part of the skb (e.g. due to an error in the payload length
reported by the NIC or if we consumed all the available fragments for
the skb), the page_pool fragment will not be linked to the skb so it will
not return to the pool in the airoha_qdma_rx_process() error path. Fix the
memory leak partially reverting commit 'd6d2b0e1538d ("net: airoha: Fix
page recycling in airoha_qdma_rx_process()")' and always running
page_pool_put_full_page routine in the airoha_qdma_rx_process() error
path. |
| In the Linux kernel, the following vulnerability has been resolved:
soc: ti: k3-socinfo: Fix regmap leak on probe failure
The mmio regmap allocated during probe is never freed.
Switch to using the device managed allocator so that the regmap is
released on probe failures (e.g. probe deferral) and on driver unbind. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: Fix some memory leaks in an error handling path of 'log_replay()'
All error handling paths lead to 'out' where many resources are freed.
Do it as well here instead of a direct return, otherwise 'log', 'ra' and
'log->one_page_buf' (at least) will leak. |
| In the Linux kernel, the following vulnerability has been resolved:
nfs: fix acl memory leak of posix_acl_create()
When looking into another nfs xfstests report, I found acl and
default_acl in nfs3_proc_create() and nfs3_proc_mknod() error
paths are possibly leaked. Fix them in advance. |
| In the Linux kernel, the following vulnerability has been resolved:
media: i2c/tw9906: Fix potential memory leak in tw9906_probe()
In one of the error paths in tw9906_probe(), the memory allocated in
v4l2_ctrl_handler_init() and v4l2_ctrl_new_std() is not freed. Fix that
by calling v4l2_ctrl_handler_free() on the handler in that error path. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix memory leak on failure path
cfg80211_inform_bss_frame() may return NULL on failure. In that case,
the allocated buffer 'buf' is not freed and the function returns early,
leading to potential memory leak.
Fix this by ensuring that 'buf' is freed on both success and failure paths. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/zcrx: fix sgtable leak on mapping failures
In an unlikely case when io_populate_area_dma() fails, which could only
happen on a PAGE_POOL_32BIT_ARCH_WITH_64BIT_DMA machine,
io_zcrx_map_area() will have an initialised and not freed table. It was
supposed to be cleaned up in the error path, but !is_mapped prevents
that. |
| In the Linux kernel, the following vulnerability has been resolved:
media: radio-keene: fix memory leak in error path
Fix a memory leak in usb_keene_probe(). The v4l2 control handler is
initialized and controls are added, but if v4l2_device_register() or
video_register_device() fails afterward, the handler was never freed,
leaking memory.
Add v4l2_ctrl_handler_free() call in the err_v4l2 error path to ensure
the control handler is properly freed for all error paths after it is
initialized. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/atmel-hlcdc: fix memory leak from the atomic_destroy_state callback
After several commits, the slab memory increases. Some drm_crtc_commit
objects are not freed. The atomic_destroy_state callback only put the
framebuffer. Use the __drm_atomic_helper_plane_destroy_state() function
to put all the objects that are no longer needed.
It has been seen after hours of usage of a graphics application or using
kmemleak:
unreferenced object 0xc63a6580 (size 64):
comm "egt_basic", pid 171, jiffies 4294940784
hex dump (first 32 bytes):
40 50 34 c5 01 00 00 00 ff ff ff ff 8c 65 3a c6 @P4..........e:.
8c 65 3a c6 ff ff ff ff 98 65 3a c6 98 65 3a c6 .e:......e:..e:.
backtrace (crc c25aa925):
kmemleak_alloc+0x34/0x3c
__kmalloc_cache_noprof+0x150/0x1a4
drm_atomic_helper_setup_commit+0x1e8/0x7bc
drm_atomic_helper_commit+0x3c/0x15c
drm_atomic_commit+0xc0/0xf4
drm_atomic_helper_set_config+0x84/0xb8
drm_mode_setcrtc+0x32c/0x810
drm_ioctl+0x20c/0x488
sys_ioctl+0x14c/0xc20
ret_fast_syscall+0x0/0x54 |
| In the Linux kernel, the following vulnerability has been resolved:
usb: misc: usbio: Fix URB memory leak on submit failure
When usb_submit_urb() fails in usbio_probe(), the previously allocated
URB is never freed, causing a memory leak.
Fix this by jumping to err_free_urb label to properly release the URB
on the error path. |
| In the Linux kernel, the following vulnerability has been resolved:
gpib: lpvo_usb: fix memory leak on disconnect
The driver iterates over the registered USB interfaces during GPIB
attach and takes a reference to their USB devices until a match is
found. These references are never released which leads to a memory leak
when devices are disconnected.
Fix the leak by dropping the unnecessary references. |
| In the Linux kernel, the following vulnerability has been resolved:
iio: gyro: mpu3050: Fix irq resource leak
The interrupt handler is setup but only a few lines down if
iio_trigger_register() fails the function returns without properly
releasing the handler.
Add cleanup goto to resolve resource leak.
Detected by Smatch:
drivers/iio/gyro/mpu3050-core.c:1128 mpu3050_trigger_probe() warn:
'irq' from request_threaded_irq() not released on lines: 1124. |
| In the Linux kernel, the following vulnerability has been resolved:
comedi: runflags cannot determine whether to reclaim chanlist
syzbot reported a memory leak [1], because commit 4e1da516debb ("comedi:
Add reference counting for Comedi command handling") did not consider
the exceptional exit case in do_cmd_ioctl() where runflags is not set.
This caused chanlist not to be properly freed by do_become_nonbusy(),
as it only frees chanlist when runflags is correctly set.
Added a check in do_become_nonbusy() for the case where runflags is not
set, to properly free the chanlist memory.
[1]
BUG: memory leak
backtrace (crc 844a0efa):
__comedi_get_user_chanlist drivers/comedi/comedi_fops.c:1815 [inline]
do_cmd_ioctl.part.0+0x112/0x350 drivers/comedi/comedi_fops.c:1890
do_cmd_ioctl drivers/comedi/comedi_fops.c:1858 [inline] |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/sysfs: fix param_ctx leak on damon_sysfs_new_test_ctx() failure
Patch series "mm/damon/sysfs: fix memory leak and NULL dereference
issues", v4.
DAMON_SYSFS can leak memory under allocation failure, and do NULL pointer
dereference when a privileged user make wrong sequences of control. Fix
those.
This patch (of 3):
When damon_sysfs_new_test_ctx() fails in damon_sysfs_commit_input(),
param_ctx is leaked because the early return skips the cleanup at the out
label. Destroy param_ctx before returning. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: fix to avoid memory leak in f2fs_rename()
syzbot reported a f2fs bug as below:
BUG: memory leak
unreferenced object 0xffff888127f70830 (size 16):
comm "syz.0.23", pid 6144, jiffies 4294943712
hex dump (first 16 bytes):
3c af 57 72 5b e6 8f ad 6e 8e fd 33 42 39 03 ff <.Wr[...n..3B9..
backtrace (crc 925f8a80):
kmemleak_alloc_recursive include/linux/kmemleak.h:44 [inline]
slab_post_alloc_hook mm/slub.c:4520 [inline]
slab_alloc_node mm/slub.c:4844 [inline]
__do_kmalloc_node mm/slub.c:5237 [inline]
__kmalloc_noprof+0x3bd/0x560 mm/slub.c:5250
kmalloc_noprof include/linux/slab.h:954 [inline]
fscrypt_setup_filename+0x15e/0x3b0 fs/crypto/fname.c:364
f2fs_setup_filename+0x52/0xb0 fs/f2fs/dir.c:143
f2fs_rename+0x159/0xca0 fs/f2fs/namei.c:961
f2fs_rename2+0xd5/0xf20 fs/f2fs/namei.c:1308
vfs_rename+0x7ff/0x1250 fs/namei.c:6026
filename_renameat2+0x4f4/0x660 fs/namei.c:6144
__do_sys_renameat2 fs/namei.c:6173 [inline]
__se_sys_renameat2 fs/namei.c:6168 [inline]
__x64_sys_renameat2+0x59/0x80 fs/namei.c:6168
do_syscall_x64 arch/x86/entry/syscall_64.c:63 [inline]
do_syscall_64+0xe2/0xf80 arch/x86/entry/syscall_64.c:94
entry_SYSCALL_64_after_hwframe+0x77/0x7f
The root cause is in commit 40b2d55e0452 ("f2fs: fix to create selinux
label during whiteout initialization"), we added a call to
f2fs_setup_filename() without a matching call to f2fs_free_filename(),
fix it. |
| An issue was discovered in Prosody before 0.12.6 and 1.0.0 through 13.0.0 before 13.0.5. A Denial of Service can occur via memory exhaustion caused by memory leaks from unauthenticated connections. |
| Memory leak in sharkd 4.6.0 to 4.6.4 and 4.4.0 to 4.4.14 allows denial of service |
| When a challenge ACK is to be sent tcp_respond() constructs and sends the challenge ACK and consumes the mbuf that is passed in. When no challenge ACK should be sent the function returns and leaks the mbuf.
If an attacker is either on path with an established TCP connection, or can themselves establish a TCP connection, to an affected FreeBSD machine, they can easily craft and send packets which meet the challenge ACK criteria and cause the FreeBSD host to leak an mbuf for each crafted packet in excess of the configured rate limit settings i.e. with default settings, crafted packets in excess of the first 5 sent within a 1s period will leak an mbuf.
Technically, off-path attackers can also exploit this problem by guessing the IP addresses, TCP port numbers and in some cases the sequence numbers of established connections and spoofing packets towards a FreeBSD machine, but this is harder to do effectively. |
